Fiber SETTING
Steel Z-Mark
Shared by Ryan G.
Result Photo
Material
- Material
- Stainless Steel
- Coating
- None
- Color
- Silver
- Thickness
- Not Applicable
Setup
- Software
- LightBurn
- Repeat All
- 1
- Focus (mm)
- 0-Values Focus Closer | +Values Focus Further
Laser
- Laser Source
- JPT YDFLP-E-50-LP-S
- Lens
- F210 / 150x150
Notes
These settings were tested on a cheap dollar store butter knife.
Fill passes
Mark Pass
- Speed (mm/s)
- 100
- Power (%)
- 55
- Frequency (kHz)
- 25
- Pulse Width (ns)
- 200
- Interval (mm)
- 0.025
- Passes
- 2
- Angle (deg)
- 0
- Type
- Bidirectional
- Crosshatch
- Enabled
- Air Assist
- Disabled
- Flood Fill
- Disabled
- Auto-Rotate
- Disabled