Fiber SETTING
Brass Plaque Black Finish
Shared by Mei L.
Result Photo
Material
- Material
- Brass
- Coating
- None
- Color
- Gold
- Thickness
- Not Applicable
Setup
- Software
- LightBurn
- Repeat All
- 1
- Focus (mm)
- 0-Values Focus Closer | +Values Focus Further
Laser
- Laser Source
- JPT YDFLP-E-50-LP-S
- Lens
- F290 / 200x200
Notes
After the engraving, I would use alcohol to wipe it down. No sanding or the black will fade. I finish it with a light coat of clear gloss spray to seal and intensify the black color.
Fill passes
Brass Pass
- Speed (mm/s)
- 800
- Power (%)
- 90
- Frequency (kHz)
- 45
- Pulse Width (ns)
- 200
- Interval (mm)
- 0.01
- Passes
- 1
- Angle (deg)
- 45
- Type
- Bidirectional
- Crosshatch
- Enabled
- Air Assist
- Disabled
- Flood Fill
- Disabled
- Auto-Rotate
- Disabled