CO2 Gantry SETTING
8mm Walnut Cut
Shared by [LE] Kyle
Result Photo
Material
- Material
- Walnut
- Coating
- None
- Color
- Brown
- Thickness
- Not Applicable
Setup
- Software
- LightBurn
- Repeat All
- 1
- Focus (mm)
- -1-Values Focus Closer | +Values Focus Further
Laser
- Laser Source
- RECI W4
- Lens Configuration
- Single SL1
- Lens
- 50.8
Notes
This was initially tested for me to complete a box to contain slate coasters. I performed the cut down-focused 1mm to get the center of focus closer to the center of the wood. If using a longer lens, may be a non-issue. I used an air assist set to ~15-18 psi.
Line passes
Thicc Cut
- Speed (mm/s)
- 10
- Power (%)
- 85
- Perforation Mode
- Disabled
- Air Assist
- Enabled